Recent Comments

    Making a quick and dirty maid’s cap

    aka I lost the damn thing again

    I won’t claim this is perfect, but I’ve yet to find a better way to do it, and I’ve made four or five of the things over the last 14 years. It beats wearing a coffee filter on your head.

    Supplies:
    *About ¼ of a yard of white cotton, not woven too tightly (1/3 of a yard would be better; don’t screw up)
    *Approx 16” of scalloped lace trim, 1.5” wide at its widest point
    *White thread, needles, pins, a ruler or tape measure

    CUT IT:
    Cut a 5.25” diameter circle (finished cap is 5” in diameter; I am including a ¼” seam allowance all the way round)

    FOLD IT:
    Pin in place three folds originating from the center back, where you’re going to put the bow. If you aren’t feeling that detail-oriented, the folds can be omitted but it won’t look as good. I suggest lighting ironing the folds into place and then tacking them down with very tiny stitches spread far apart (you want it to look natural).

    DECORATE IT:
    Pin under the seam allowance and either baste it down now or pin the lace underneath it so you can sew on the lace and sew under the seam allowance at the same time. (It saves time, sort of, but it’s fiddly and harder to take apart later.) Pin the lace so it overlaps itself at the center back, under where you’re going to put the bow so the join won’t show.

    For the ribbon:
    Cut a 21.5”x 3.5” rectangle of the same white fabric (I used 21.5” last time; up to 23” or so is fine; again, this includes a ¼” seam allowance all around.)

    Fold the ribbon right side to right side and sew along the edge ¼” from the edge, making a tube. Turn the tube inside out so the right sides are on the outside. Cut the ends diagonally, making a trapezoid.

    ——————————–
    \________________/

    Finish the ends, tucking the ragged ends in and sewing them inside your trapezoid.

    (Yes, you could just use 1.5” width white ribbon…but it looks crappy. The texture’s wrong, and it won’t have the correct body when you tie it into a bow.)

    Tie your trapezoid “ribbon” into a bow, keeping the two “tails” of the bow about the same length. The center of the bow shouldn’t be totally flat; let it have a little body.

    Tack the bow onto the cap at the base of your radiating folds (or just where you overlapped the lace if you skipped the folds). Tack down both the loops and the center of the bow to the cap with double thread; it’s sort of heavy.

    WEAR IT:
    I find the best way to attach the cap is with bobby pins. (Take them off after every wearing; I used to leave them attached but got rust stains when my costume bag got damp. Just don’t do it.)
    Slide one bobby pin along each side and one along the back under your bow so it doesn’t flop around. Buy auburn or white bobby pins.

    TIP: Some Magentas suggest making thread loops or making small loops out of satin cord underneath on either side for the bobby pins so they don’t show. I’ve been Magenting for more than 30 years and never found it necessary.